G3 Fax Error Code

Transmission system error code

If the machine encounters a problem while sending a G3 fax, an error dialog will appear and error codes will be displayed in Txx format. Take corrective actions by referring to the table below.

Code

Corrective Actions

T00

  • Check to see if the destination is correct.

  • Check the state of the recipient.

T05

Check the state of the recipient.

T08

Check the line status.

T18

Check the state of the recipient.

T28

Check the state of the recipient.

T32

Check the line status.

T42

Check the line status.

T43

Check the line status.

T48

  • Check to see if the destination is correct.

  • Check that the fax number registered with the recipient is correct.

T51

Check the line status.

T58

The document to be sent by polling is not registered in the sender's machine. Ask the sender to set the document.

T60

Register the document that is sent to the recipient by polling.

T61

Check whether the document to be sent by polling from the bulletin board is registered.

T62

Inform the recipient of the correct bulletin board number.

T80

Check the line status.

T81

Check the line status.

T82

  • Check to see if the destination is correct.

  • Check the state of the recipient.

T85

Check the line status.

T89

Check the balance in the billing management device.

T90

Specify the line that is used for sending.

T91

Specify a different line to use to send data.

T95

Check the line status.

T97

Check the state of the fax board. (Contact your service representative. )

T98

Forwarding is not available for that combination. Check the forwarding settings.

T99

Check the destinations registered in the address book.

Reception system error code

If the machine encounters a problem while receiving a G3 fax, an error dialog will appear and error codes will be displayed in Rxx format. Take corrective actions by referring to the table below.

Code

Corrective Actions

R18

Check your machine. If toner or print paper is empty, supply them. If the memory is full, empty the memory.

R21

Turn the Closed Network RX function off, or inform the recipient of the correct password.

R22

Turn the Closed Network RX function off, or inform the recipient of the correct password.

R32

Change the setting for Auto Create User Box, or inform the recipient of the correct Confidential User Box number.

R50

Check the line status.

R51

Check the line status.

R60

Check the line status.

R63

Check the line status.

R69

Check the line status.

R72

Ask the sender to shorten the length of original to be sent before resending the fax.

R78

Turn the Main Power Switch off and back on.

R79

Turn the Main Power Switch off and back on.

R93

  • After checking with the sender, register a Confidential User Box for confidential reception.

  • Check the password for the Confidential User Box.

R94

  • After checking with the recipient, register a Relay User Box for relay distribution.

  • Check the password for the Relay User Box.

R95

Check Forward TX Setting.

R96

Inform the recipient of the correct number for the Confidential User Box.

R97

Check PC-Fax RX Setting.

R99

Turn the Main Power Switch off and back on.