Specifying the Original Size and Scan Method

Specifying the original size ([Original Settings])

Select the size of the original to be scanned. Select the key that shows the same size as for the original to be scanned.

To scan an original of custom size, manually specify the size.

For details, refer to [Original Size] .

Specifying the original binding position ([Binding Position])

When scanning a 2-sided original, specify the binding position of the original in [Binding Position] to prevent the binding position from being reversed between the front and rear faces.

For details, refer to [Binding Position] .

Specifying the original loading direction ([Original Direction])

When scanning a 2-sided original etc..., you can specify the original loading direction so that the vertical direction is set correctly.

For details, refer to [Original Direction] .

Scanning originals of varying sizes in a batch ([Mixed Original])

Using the ADF allows you to collectively scan the originals of paper sizes 8-1/2 by 11 and 8-1/2 by 14, which have the same width.

For details, refer to [Mixed Original] .

Scanning a number of originals ([Separate Scan])

If the number of original sheets is so large that they cannot be loaded into the ADF at the same time, you can load them in several batches and handle them as one job.

In [Separate Scan], you can switch between the ADF and Original Glass for scanning the originals.

  1. Load the original.

    NOTICE

    • Do not load more than 50 sheets (21-1/4 lb (80 g/m)) at a time into the Original Tray, and do not load the sheets up to the point where the top of the stack is higher than the Down-pointing triangle mark. Doing so may cause an original paper jam, damage the originals, and/or load to the ADF failure.

  2. Tap [Application] - [No. of Originals] - [Separate Scan], and set to [ON].

  3. Press the Start key.

    The original is scanned.

  4. Load the next original, then press the Start key.

    supplementary explanationIf desired, tap [Change Setting] to change the copy settings according to the new original.

  5. Repeat Step 4 until all originals are scanned.

  6. After all originals are scanned, tap [Finish] and press the Start key.

    Copying begins.

Related setting

  • Select whether to always scan originals continuously without specifying [Separate Scan] when scanning originals using the Original Glass (Default: [No]). For details, refer to [Separate Scan from Platen] .

  • You can select the timing that the copy begins when scanning an original by specifying [Separate Scan]. (Default: [Page Print]) For details, refer to [Separate Scan Output Method] .

Copying multiple originals in different settings collectively ([Program Jobs])

Originals are scanned with different settings for each set, and copied collectively. Use this function when various types of originals are mixed, such as 1-sided original to be printed on one side of paper, and 2-sided original to be copied by enlarging. After all originals have been scanned, you can add page numbers or finishing functions, such as sort, to copy them.

precondition When you set [Program Jobs], [Group] cannot be selected in [Finishing].

  1. Load the original.

  2. Tap [Application] - [Other] - [Program Jobs], and set to [ON].

  3. Configure the copy settings, then press the Start key.

    The original is scanned.

  4. To fix the scan result, tap [Yes].

    supplementary explanation To scan the original again, tap [No]. Tap [Change Setting] to change the copy settings.

  5. Load the next original, then tap [Change Setting].

  6. Configure the copy settings, then press the Start key.

    supplementary explanation Repeat Steps 3 to 5 until all originals have been scanned.

  7. After all original pages have been scanned, tap [Finish].

  8. Tap [Yes].

  9. Specify finish settings as required, then tap [Start].

    Copying begins.