LK-114_SetupTool

LK-114_SetupTool

LK-114_SetupTool allows you to only set up the configuration of the topology machine in a serverless pull printing group.

To add a storage machine or client machine to a serverless pull printing group or change the configuration of storage and client machines in a serverless pull printing group after setting up the configuration of the topology machine in a serverless pull printing group using LK-114_SetupTool, configure settings on the MFP.

Tips

  • LK-114_SetupTool is not available in the IPv6 environment. To use the serverless pull printing function in the IPv6 environment, configure settings on the MFP. For details, refer to [Serverless Pull Printing Settings] .

System environment requirements

For details on the system requirements, refer to [LK-114_SetupTool (for the administrator)] .

Preparation required to use this function

To use LK-114_SetupTool, configure NetBIOS settings on the computer.

preconditionThe following describes how to configure NetBIOS settings in the Windows 7 environment.

  1. From the Start menu, click [Control Panel] - [Network and Internet] - [Network and Sharing Center] - [Local Area Connection].

  2. Click [Properties].

  3. From the connection item list, select [Internet Protocol Version 4 (TCP/IPv4)], then click [Properties].

  4. Click [Preferences].

  5. On the [WINS] tab of the [Advanced TCP/IP Settings] page, configure NetBIOS settings, then click [OK].

    supplementary explanationClear the [Enable LMHOSTS lookup] check box.

    supplementary explanationIn [NetBIOS Settings], select [Disable NetBIOS over TCP/IP].

  6. From the Start menu, click [All Programs] - [Accessories] - [Command Prompt].

  7. Execute the "ipconfig /flushdns" command.

    supplementary explanationInsert a space between "ipconfig" and "/flushdns".

    The message shown below appears.

    NetBIOS settings are then completed.