Loading the Original into the ADF
Original available for ADF
Item | Specifications | |
---|---|---|
Original types | 1-Sided | Thin paper (9-5/16 lb to 13-1/16 lb (35 g/m2 to 49 g/m2)) Plain paper (13-5/16 lb to 34-1/16 lb (50 g/m2 to 128 g/m2)) |
2-Sided | Plain paper (13-5/16 lb to 34-1/16 lb (50 g/m2 to 128 g/m2)) | |
Mixed original | Plain paper (13-5/16 lb to 34-1/16 lb (50 g/m2 to 128 g/m2)) | |
Original Size | 1-Sided/2-Sided Originals: 11 17 to 5-1/2 8-1/2 , A3 to A6 Fax mode: 5-1/2 inches to 39-3/8 inches (139.7 mm to 1000 mm) | |
Original loading capacity | 1-Sided/2-Sided Originals: Max. 100 sheets (21-1/4 lb (80 g/m2)) |
Do not load the following originals into the ADF. Doing so may cause an original paper jam, or damage the originals.
Wrinkled, folded, curled, or torn originals
Highly translucent or transparent originals, such as transparencies or diazo photosensitive paper
Coated originals such as carbon-backed paper
Original that weighs less than the basic weight of 9-5/16 lb (35 g/m2), or more than 34-1/16 lb (128 g/m2)
Originals that are bound, for example, with staples or paper clips
Originals that are bound in booklet form
Originals with pages bound together with glue
Originals with pages that have had cutouts removed or are cutouts
Label sheets
Offset printing masters
Loose leaf loaded in the direction
If there are too many original sheets that cannot be loaded into the ADF at the same time, you can load them in several batches and handle them as one job. For details, refer to [Scanning a number of originals (Separate Scan)] .
For an original with pages of different sizes, you can collectively load them into the ADF, and scan data while detecting the size for each page. For details, refer to [Scanning originals of varying sizes in a batch (Mixed Original)] .
Loading the original into the ADF
The ADF feeds original sheets one by one in order from the top, and automatically loads them. It also loads a 2-sided original automatically.
The ADF is helpful when loading a large number of original.
Widen the Lateral Guide.
Put the first page of an original at the top, and load the original into the Original Tray with the required side facing upward.
Load the original so that its top side is placed at the back. When loading in a different orientation, be sure to specify the loading direction of originals.
For details on the loading direction of originals, refer to [Specifying the original loading direction (Original Direction)] .
NOTICEDo not load more than 100 sheets (21-1/4 lb (80 g/m)) at a time into the Original Tray, and do not load the sheets up to the point where the top of the stack is higher than the mark. Doing so may cause the originals to jam, damage the originals, and/or an ADF failure. However, if the original contains more than 100 sheets (21-1/4 lb (80 g/m)), it can be scanned separately.
Slide the Lateral Guide to fit the loaded original.