Setting the action for switching the display to Enlarge Display

The default display mode of the Touch Panel can be set to Enlarge Display mode. You can also set the action to be taken when the display mode is switched to Enlarge Display.

In the administrator mode, select [System Settings] - [Enlarge Display Settings], then configure the following settings.

Settings

Description

[Default Enlarge Display Setting]

Select whether to use Enlarge Display mode as the initial display of the Touch Panel.

[OFF] is specified by default.

[Enlarge Display Setting]

If you have set [Default Enlarge Display Setting] to [ON], select whether to enable Enlarge Display mode when the Reset key is pressed.

If you wish to enable Enlarge Display mode when the Reset key is pressed, select [Enlarge].

[Normal] is specified by default.

[Apply Basic Setting to Enlarge Display]

Select whether to inherit the settings configured on the normal screen display when switching the screen from Normal to Enlarge Display.

  • [Mode 1]: Inherit all normal mode settings.

  • [Mode 2]: In Copy mode, only inherit Normal mode settings that can be set in Enlarge Display mode. In Fax/Scan mode, reset the settings.

[Mode 2] is specified by default.