Replacing a Staple Cartridge
Finisher FS-540/Finisher FS-540 SD
1
Open the Front Door of the Finisher.
2
Unlock the Staple Cartridge.
3
Pull out the Staple Cartridge.
4
Pull out an empty staple case from the Staple Cartridge.
5
Insert a new staple case into the Staple Cartridge.
6
Insert the staple case until it hits the back of the Staple Cartridge, and check that it is locked.
7
Attach the Staple Cartridge.
8
Close the Front Door of the Finisher.
Tips
- Do not remove staples that remain in the machine. Otherwise, the stapling function will activate but no sheets will be stapled.
NOTICE
- Be sure to replace the Staple Cartridge after the relevant message has appeared. If a Staple Cartridge is removed before the relevant message appears, it may result in a failure.
Finisher FS-539/Finisher FS-539 SD
1
Open the Front Door of the Finisher.
2
Unlock the Staple Cartridge.
3
Pull out the Staple Cartridge.
4
Remove any empty staple cases from the Staple Cartridge.
5
Attach a new staple case to the Staple Cartridge.
6
Attach the Staple Cartridge.
7
Close the Front Door of the Finisher.
Tips
- Do not remove staples that remain in the machine. Otherwise, the stapling function will activate but no sheets will be stapled.
NOTICE
- Be sure to replace the Staple Cartridge after the relevant message has appeared. If a Staple Cartridge is removed before the relevant message appears, it may result in a failure.
Finisher FS-533
1
Pinch the Lock Release Lever, and slide the Finisher.
2
Pull the Punch Kit Release Lever[FS2] in the arrow direction, and open the Punch Kit.
3
Unlock the Staple Cartridge.
4
Pull out the Staple Cartridge.
5
Remove any empty staple cases from the Staple Cartridge.
6
Attach a new staple case to the Staple Cartridge.
7
Attach the Staple Cartridge.
8
Close the Punch Kit.
9
Close the Finisher.
Tips
- Do not remove staples that remain in the machine. Otherwise, the stapling function will activate but no sheets will be stapled.
NOTICE
- Be sure to replace the Staple Cartridge after the relevant message has appeared. If a Staple Cartridge is removed before the relevant message appears, it may result in a failure.
Finisher FS-P04
1
Turn the Finisher FS-P04 by 90 degrees.
2
Open the cover.
3
Pull out the Staple Cartridge.
4
Lift an empty Staple Case while holding its both edges, then pull out it from the Staple Cartridge.
5
Mount a new Staple Cartridge in the Staple Case.
6
Insert the Staple Cartridge until it clicks.
7
Close the cover.
8
Turn the Finisher FS-P04 by 90 degrees to return it to the home position.
in the upper-right of a page, it turns into 
and is registered as a bookmark.