Configure SA (Security Association) required for encrypted communication. Up to 10 groups can be registered for the SA.
Select a group, then tap [Edit].
To register SA, select [ON].
[OFF] is specified by default.
Enter the SA name (using up to 10 characters).
Select an IPsec operation mode.
[Transport Mode] is specified by default.
[Tunnel End Point]
If [Tunnel Mode] is selected in [Encapsulation Mode], enter the IP address of the IPsec gateway that is used as a peer.
Select a security protocol.
[Key Exchange Method]
Select the key replacement method to securely create a common key used to encrypt communications.
When using a device that does not support the automatic key replacement by IKE, select [Manual Key] to manually configure detailed parameters.
[IKEv1] is specified by default.
[Lifetime After Establishing SA]
Enter the lifetime of a common key used to encrypt communications.
 is specified by default.
To check the registered SA settings, select a group name, then tap [Mode Check].