HomeDescriptions of Functions / Utility KeysPunch Horizontal Position Adjustment

Punch Horizontal Position Adjustment

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Punch Horizontal Position Adjustment]

If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch hole positions.

Copy after configuration, then repeat adjustments as required.

ineo+ 658/558/458: This adjustment is possible when the Finisher FS-537/FS-537 SD and Punch Kit PK-523 are installed.

Settings

Description

[Finisher]/[Post Inserter]

Select the position subject to punch hole position adjustment.

  • [Post Inserter]: An adjustment is possible when the Post Inserter is installed on the machine.

[Adjust Value]

Enter an adjustment value between -5.0 and 5.0 mm by tapping [-] and [+].

  • [-]: Move the punch position to the left.

  • [+]: Move the punch position to the right.

[0.0 mm] is specified by default.

ineo+ 658/558/458: This adjustment is possible when the Finisher FS-536/FS-536 SD and Punch Kit PK-520 are installed.

ineo+ 368/308/258: This adjustment is possible when the Finisher FS-534/FS-534 SD and Punch Kit PK-520 are installed.

Settings

Description

[Paper Type]

Select the type of paper subject to punch hole position adjustment.

[Adjust Value]

Enter an adjustment value between -10 and 10 by tapping [-] and [+].

  • [-]: Move the punch position to the left.

  • [+]: Move the punch position to the right.

[0] is specified by default.

  • Make adjustment while checking a sheet of paper having punched holes that are not in the correct positions.