HomeDescriptions of Functions / Utility KeysHalf-Fold Position

Half-Fold Position

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Half-Fold Position]

If the half-fold position is not on the exact center of the paper, use this option to align the fold on the center.

Copy after configuration, then repeat adjustments as required.

Settings

Description

[Paper Size]

Select the size of paper that is used to adjust the fold position.

[Adjust Value]

Enter an adjustment value between -10.0 and 10.0 mm by tapping [-] and [+].

  • [-]: Move the fold position to the left.

  • [+]: Move the fold position to the right.

[0.0 mm] is specified by default.

  • ineo+ 658/558/458:
    To use this function, the optional Finisher FS-537 SD or the optional Finisher FS-536 SD is required.

  • ineo+ 368/308/258:
    To use this function, the optional Finisher FS-534 SD is required.

  • Adjust the half-fold position before adjusting the center staple position.

  • Make adjustment while checking paper folded at a displaced position.

  • The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.

  • For adjustments to put the fold position parallel with the left edge of paper, contact your service representative for instructions.