Home
ApplicationColor Centro : Application of Image Controller IC-603 for color managementColor Default Settings
ApplicationColor Centro : Application of Image Controller IC-603 for color managementColor Default SettingsApplication
- Color Centro : Application of Image Controller IC-603 for color management
- Overview of Color Centro
- Set up Color Centro
- Basic Information of Color Centro
- Color Management with Color Centro
- Calibration
- Calibration Manager Screen
- Operate on the Calibration Manager Screen
- Tone Curve Adjustment
- Tone Curve Adjustment Screen
- Operate on the Tone Curve Adjustment Screen
- Spot Color
- Spot Color Screen
- Operate on the Spot Color Screen.
- Load of a Spot Color Table
- Create a Spot Color Table
- Selection and Addition of a Spot Color
- Add a Spot Color that is Measured by using a Colorimeter
- Adjust a Spot Color Manually
- Adjust a Spot Color by using a Printed Chart
- Save a Spot Color Table
- Change the Priority of a Spot Color Table
- Management of Spot Color Tables
- Management of Spot Colors
- Search for a Spot Color
- Reset the Screen
- Alternative Color Management
- Profile Management
- Profile Management Screen
- Management of RGB Source Profiles
- Management of CMYK Target Profiles
- Creation of a CMYK Target Profile
- Management of Printer Profiles
- Creation of a Printer Profile
- Management of RGB-CMYK Device Link Profiles
- Creation of an RGB-CMYK Device Link Profile
- Editing of an RGB-CMYK Device Link Profile
- Management of CMYK-CMYK Device Link Profiles
- Creation of a CMYK-CMYK Device Link Profile
- CMYK-CMYK DLP (Creation): Start Color Centro Profiler
- CMYK-CMYK DLP (Creation): Select Profiles
- CMYK-CMYK DLP (Creation): Specify Color Conversion
- CMYK-CMYK DLP (Creation): Enter a Profile Name
- CMYK-CMYK DLP (Creation): Confirm the Result of the Calculation
- CMYK-CMYK DLP (Creation): Select a Task
- CMYK-CMYK DLP (Creation): Feed Back Measurement Values
- CMYK-CMYK DLP (Creation): Complete the Procedure
- Editing of a CMYK-CMYK Device Link Profile
- Color Default Settings
- Color Configuration Management
- Profile Set
- Color Configuration
- Color Configuration Management Screen
- Create a Color Configuration
- Edit a Color Configuration
- Register a Color Configuration
- Management of Color Configurations
- Creation of a Profile Set
- Editing of a Profile that Composes a Profile Set
- Improvement of Accuracy of a Profile Set
- Adjustment of Color Conversion of a Profile Set
- Management of Profile Sets
- Specify Environment on Color Centro Profiler
- Other Functions
- Troubleshooting
Color Default Settings
You can specify default color settings for color conversion.
You specify the settings to use tone curves, spot colors, and alternative colors.
The specified defaults are applied when:
no special option is specified using the printer driver;
direct printing is performed; or
settings that require the default settings of the image controller are configured.
Also, using Color Centro, the following functions are available.
Creation and editing of profile set
Management, creation, and editing of color configuration
This section describes how to configure the default settings of the color profile by using Color Centro.