Home
ApplicationColor Centro : Application of Image Controller IC-603 for color managementSet up Color CentroSettings of the Image Controller
ApplicationColor Centro : Application of Image Controller IC-603 for color managementSet up Color CentroSettings of the Image ControllerApplication
- Color Centro : Application of Image Controller IC-603 for color management
- Overview of Color Centro
- Set up Color Centro
- Basic Information of Color Centro
- Color Management with Color Centro
- Calibration
- Calibration Manager Screen
- Operate on the Calibration Manager Screen
- Tone Curve Adjustment
- Tone Curve Adjustment Screen
- Operate on the Tone Curve Adjustment Screen
- Spot Color
- Spot Color Screen
- Operate on the Spot Color Screen.
- Load of a Spot Color Table
- Create a Spot Color Table
- Selection and Addition of a Spot Color
- Add a Spot Color that is Measured by using a Colorimeter
- Adjust a Spot Color Manually
- Adjust a Spot Color by using a Printed Chart
- Save a Spot Color Table
- Change the Priority of a Spot Color Table
- Management of Spot Color Tables
- Management of Spot Colors
- Search for a Spot Color
- Reset the Screen
- Alternative Color Management
- Profile Management
- Profile Management Screen
- Management of RGB Source Profiles
- Management of CMYK Target Profiles
- Creation of a CMYK Target Profile
- Management of Printer Profiles
- Creation of a Printer Profile
- Management of RGB-CMYK Device Link Profiles
- Creation of an RGB-CMYK Device Link Profile
- Editing of an RGB-CMYK Device Link Profile
- Management of CMYK-CMYK Device Link Profiles
- Creation of a CMYK-CMYK Device Link Profile
- CMYK-CMYK DLP (Creation): Start Color Centro Profiler
- CMYK-CMYK DLP (Creation): Select Profiles
- CMYK-CMYK DLP (Creation): Specify Color Conversion
- CMYK-CMYK DLP (Creation): Enter a Profile Name
- CMYK-CMYK DLP (Creation): Confirm the Result of the Calculation
- CMYK-CMYK DLP (Creation): Select a Task
- CMYK-CMYK DLP (Creation): Feed Back Measurement Values
- CMYK-CMYK DLP (Creation): Complete the Procedure
- Editing of a CMYK-CMYK Device Link Profile
- Color Default Settings
- Color Configuration Management
- Profile Set
- Color Configuration
- Color Configuration Management Screen
- Create a Color Configuration
- Edit a Color Configuration
- Register a Color Configuration
- Management of Color Configurations
- Creation of a Profile Set
- Editing of a Profile that Composes a Profile Set
- Improvement of Accuracy of a Profile Set
- Adjustment of Color Conversion of a Profile Set
- Management of Profile Sets
- Specify Environment on Color Centro Profiler
- Other Functions
- Troubleshooting
Settings of the Image Controller
Configure the network settings for the image controller.
This section describes the machine settings.
[TCP/IP Settings]: Specify the IP address on this machine.
[JSP Setting]: Specify [JSP Setting] to [ON], and [Authentication Setting] to [Invalid].
The initial port numbers are 30081 and 30082. Normally, you do not need to change them.
JSP stands for JavaServer Pages.
SSL and TLS: To use SSL or TLS, execute the following steps. To connect to Color Centro, select the port number and [SSL/TLS] in Color Centro.
Registration of device certificate
Setting of [Use SSL/TLS] and [Port Number (SSL/TLS)]
