Finisher FS-531 (Punch Kit PK-512/Punch Kit PK-513)
No. | Name | Description |
|---|---|---|
1 | Finisher front door | Opens for staple supply, removal of paper jam, and also for removal of waste paper if the machine is mounted with Punch Kit PK-512/Punch Kit PK-513. |
2 | Primary (main) tray | Holds non offset, offset, or stapled sets. |
3 | Secondary (sub) tray | Holds sets output in non offset mode. |
4 | Lever[FN4] | Opens rightward for removal of paper jam. |
5 | Lever[FN1] | Opens leftward for removal of paper jam. |
6 | Knob[FN3] | Turned to allow removal of paper jam. |
7 | Lever[FN2] | Opens downward for removal of paper jam. |
8 | Lever[FN5] | Opens lower leftward for removal of paper jam. |
9 | Knob[FN7] | Turned to allow removal of paper jam. |
10 | Handle[FN6] | Withdraws the unit for removal of paper jam in the stacker unit, or for staple supply. |
11 | Punch Kit PK-512/Punch Kit PK-513 (option) | Punches file holes in output sheets. |
12 | Punch kit scrap box (option) | Holds waste paper punched out. |
13 | Staple cartridge | Removed for staple supply and added with staples. |
DO NOT put your hand on the top of printed sheets when removing them from the primary (main) tray.
Failure to do so may cause unexpected injury, such as getting your fingers squeezed between the main body and the tray going upward. Please be sure to hold both front and rear sides of paper when removing printed sheets from the tray.