Replenishing Paper Feeder Unit PF-602m with Paper
To use paper other than loaded in a tray, change the setting of that tray in [Paper Setting] from the [MACHINE] screen or [COPY] screen.
Withdraw the tray to be replenished with paper.
Trays cannot be withdrawn when the machine is not powered. Be sure to turn the sub power switch ON.
Only one tray can be withdrawn at a time.
To load a different size of paper, proceed to step 2. To load the same size as loaded before, proceed to step 5.
Fully widen the side guide plates and rear guide plate.
Turn the guide fixing knobs(4 pieces) of the side guide plate counterclockwise to loosen them.
Fully widen the side guide plates and rear guide plate while pressing the lock release lever of each guide plate.
When moving the side guide plates, be sure to hold the lock release lever of the front one and the handle of the rear one. If moved only with the front side guide plate, the side guide plates may not be fixed in position.
Pushing the lock release lever of the side guide plate, move the side guide plate to an appropriate position according to the size indication provided on the tray bottom plate.
Turn the four guide fixing knobs of the side guide plate clockwise to fix the guides.
Load paper with the print side up.
Align the stack of paper to the left side of the tray.
Do not load above the limit level indicated on the side guide plate of the tray.
The two side guide plates are provided with small size guides. Be sure to open them only when loading paper of the width less than 182 mm / 7.15".
For details about how to use small size guides, refer to Replenishing Paper Feeder Unit PF-602m with Small Size Paper.
Align the rear guide plate to the paper.
Press the lock release lever of the rear guide plate to move it to the edge of the paper.
Be sure that the rear guide plate is securely aligned to the paper. If any gap is left between the rear guide plate and paper, the machine cannot detect the correct paper size, and machine trouble may be caused.
Push in the tray until it locks into place.
The Amount indicator of the tray will change from
to 
on the [MACHINE] screen and [COPY] screen.Do not push the tray into the machine forcibly. Otherwise, machine trouble may be caused due to unexpected shock.