Lead Edge Erase Adjustment: Adjusting the Amount of Image Erasure for Printing

Adjust the amount of image to be erased from the edge of the sheet.

Adjustment Range: -20 to +40 (1 step = 0.1 mm)

1. Follow the procedure on Administrator Setting to display the [Administrator Setting Menu] screen.

2. Press [System Setting] on the [Administrator Setting Menu] screen, and then press [Expert Adjustment], [Printer Adjustment], and [Lead Edge Erase Adjustment] in sequence.

   The [Lead Edge Erase Adjustment] screen is displayed.

3. Press [Print Mode].

   

   The [PRINT MODE] screen is displayed.

4. Select A3 or 11 17 paper, then press Start on the control panel.

   A sample pattern will be output.

5. Press [Exit PrintMode] to return to the [Lead Edge Erase Adjustment] screen.

6. Measure the resultant restart timing.

7. If any adjustment is required, enter the desired adjustment value using the touch panel keypad.

   • Use [+/-] to specify the value to be positive or negative.

   • Press [Set] to change the current value.

8. Repeat steps 3 to 7 until the desired result is obtained.

9. Press [Return] to return to the [Printer Adjustment Menu] screen.