Glue Finish Position: Adjusting the Glue Finish Position on the Body Set
Adjust the position to finish gluing on the body page and adjust the amount of glue using Perfect Binder PB-503. The sizes referred to in this section are those of bodies corresponding to cover sizes.
Objects of Adjustment:
Ahead: Offset for All Size, A4 
, B5 , A5 
/, 8.5 
11 , 5.5 8.5 , 16K , Custom (220 - 379 mm), Custom (148 - 219 mm)
Back: Offset for All Size, A4 , B5 , A5 /, 8.5 11 , 5.5 8.5 , 16K , Custom (220 - 379 mm), Custom (148 - 219 mm)
If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].
Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.
Press [Finisher Adjustment], [Perfect Binder Adjustment], and [Glue Finish Position] in sequence.
Load cover paper in either Perfect Binder Cover Tray or any other tray.
Load paper for body sets in the desired tray.
Select the size to be adjusted using [
] or [
].
Press [Print Mode].
Select the tray loaded with paper for body sets.
Press Start on the control panel.
A sample pattern of perfect-bound book is printed.
Check that the glue finishes in proper position on both frontward and backward ends of the body set.
[1] Body pages [2] Finish position of frontward gluing [3] Finish position of backward gluing
If any adjustment is required, press [Exit PrintMode] to return to the [Glue Finish Position Adjustment] screen.
Select either [Ahead] or [Back].
Use the touch panel keypad to enter the set value.
Use [+/-] to specify the value to be positive or negative.
Press [Set] to change the current value.
Adjustment Range: -128 ([To decrease]) to +127 ([To increase]) (1 step = 0.1 mm)
Repeat steps 6 to 12 until the desired result is obtained.
Press [Return].
The screen returns to the [Perfect Binder Adjustment Menu] screen.