Home Settings and AdjustmentsPunch Vertical Position Adj.: Adjusting the Vertical Position of Punch Holes

Punch Vertical Position Adj.: Adjusting the Vertical Position of Punch Holes

Adjust the vertical position of punch holes made by Folding Unit FD-503. Adjust the distance between punch holes and paper edge.

Objects of Adjustment:
2-Hole: Offset for All Size, A3 , B4 , SRA4 , A4 , B5 , A4 , A5 , B5 , A5 , 12 18 , 11 17 , 8.5 14 , 8.5 11 , 8.5 11 , 8.125 13.25 , 8.5 13 , 8.25 13 , 8 13 , 8K , 16K , 16K , 9 11

3 Hole / 4 Hole: Offset for All Size, A3 , B4 , SRA4 , A4 , B5 , 12 18 , 11 17 , 8.5 11 , 8K , 16K , 9 11

  • If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].

  1. Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.

  2. Press [Finisher Adjustment], [Multi Folder Adjustment], [Multi Folder (Punch) Adj.], and [Punch Vertical Position Adj.] in sequence.

  3. Select [2-Hole Punch], [3-Hole Punch], or [4-Hole Punch].

    • The number of punch holes varies depending on the country/region in which the machine is used.

  4. Select the size to be adjusted using [] or []. 

  5. Press [Print Mode].

  6. Load the paper with the size to be adjusted, then select that tray.

  7. Press Start on the control panel.

    A sample pattern will be output.

  8. Measure the distance (a) from the edge of the printed paper to the center of punch holes.

    Number of punch holes

    Allowance

    2 holes /4 holes

    10.5 mm ± 4.0 mm or more

    3 holes

    9.5 mm ± 4.0 mm or more

  9. If any adjustment is required, press [Exit PrintMode] to return to the [Punch Vertical Position Adjustment] screen.

  10. Use the touch panel keypad to enter the set value.

    • Use [+/-] to specify the value to be positive or negative.

    • Press [Set] to change the current value.

    • Adjustment Range: -40 ([To move to the center]) to +40 ([To move to the edge]) (1 step = 0.1 mm)

    2-Hole

    3-Hole

    4-Hole

  11. Repeat steps 5 to 10 until the desired result is obtained.

  12. Press [Return].

    The screen returns to the [Punch Vertical Position Adjustment Menu] screen.