Home Settings and AdjustmentsHorizontal Position Adj.(FD): Adjusting the Paper Feed Direction on Punch Hole Positions

Horizontal Position Adj.(FD): Adjusting the Paper Feed Direction on Punch Hole Positions

Adjust the distance from the edge of the printed paper to the center of punch holes in Punch Kit PK-522 mounted on Finisher FS-532.

Objects of Adjustment: Offset for All Size, A3 , A4 , A4 , SRA4 , A5 , B4 , B5 , 8K , 16K , 16K , 8.5  14 , 8.5  11 , 8.5  11 , 12  18 , 8.12  13.2 , 11  17 , 8.5  13 , 8.25  13 , 8 13 , 5.5  8.5 , 9  11 , B5

  • If a numeric value is specified for [Offset for All Size], it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for [Offset for All Size].

  1. Press [Adjustment] on the [MACHINE] screen to display the [Adjustment Menu] screen.

  2. Press [Finisher Adjustment], [Staple Finisher Adjustment], [Staple Finisher(Punch) Adj.], and [Horizontal Position Adj.(FD)] in sequence.

  3. Select the size to be adjusted using [] or []. 

  4. Press [Print Mode].

  5. Load the paper size selected in step 3, then select that tray key.

    • For [Output Setting], [Punch] is automatically selected.

  6. Press Start on the control panel.

    A sample pattern will be output.

  7. Measure the distance (a) from the edge of the printed paper to the center of punch holes.

    • Allowance: a = 12 mm ± 3 mm

  8. Press [Exit PrintMode] to return to the [Horizontal Position Adj.(FD)] screen.

  9. If any adjustment is required, use the touch panel keypad to enter the set value.

    • Adjustment Range: ([Far]) -50 to +50 ([Close]) (1 step = 0.1 mm)

    • Press [+/-] to specify the value to be positive or negative.

  10. Press [Set] to change the setting with the Current Data.

  11. Repeat steps 4 to 10 until the desired result is obtained.

  12. Press [Return].

    The screen returns to the [Staple Finisher(Punch) Adjustment Menu] screen.