Printer Status

[Ready]

Shows that the main body has no error.

[Sub Power Off]

Shows that the sub power source of the machine is off.

[Time-out]

Shows that the machine is in the sleep status or the communication is suspended between Job Centro and the printer.

[Service Call]

Shows that the service call failure occurs at the main body or the image controller.

[Cover Open]

Shows that the door of the main body is open.

[Paper Jam]

Shows that the paper jam occurs in a place other than ADF. Remove the jammed paper following the instructions displayed on the touch panel.

[ADF Jam]

Shows that the paper jam has occurred in ADF.

[Output Tray Full]

Shows that either of output trays is full.

[Toner Empty]

Shows that the toner level of either of toner bottles is empty.

[Humidifier Tank Empty]

Shows that the humidifier tank is empty.

[No Paper]

Shows that paper needs to be replenished for the job currently printing.

[Administrator Mode]

Shows that the machine is in the administrator mode.

[Hold Job Full]

Shows that the Hold job list is full.

[Waste Toner Full]

Shows that the waste toner box is full.

[Punch Dust Full]

Shows that the punch-hole scraps box is full.

[Trim Scrap Full]

Shows that the trimmer receiver is full.

[Staple Empty]

Shows that the staple cartridge is empty.

[Ring Bind Part Empty]

Shows that ring bind parts runs out.

[Life Limit]

Shows that the paste hopper for the perfect binding is empty or it is necessary to exchange the SD trimmer receiver.

[HDD Near Full]

Shows that the HDD is running out of space.

[Toner Near Empty]

Shows that the toner level of either of toner bottles is low.

[Near Life Limit]

Shows that the life limit of the SD trimmer receiver is near.

[Maintenance Required]

Shows that the life limit of the consumables are over.

[Low Power Mode]

Shows that the machine is in the low power mode.

[Shut Off]

Shows that the machine is shut off.

[Warming Up]

Shows that the machine or the perfect binding option are warming up.

[Now Adjusting]

Shows that the machine is now adjusting.

[Envelope Only]

If device is in envelope mode, the [Envelope Only] is displayed under the status message.