Making a Copy

Copying (basic operation flow)

This section describes the basic procedure to make a copy in Enlarge Display mode.

  1. Load the original.

  2. Tap [Copy] on the main menu of classic style.

  3. Tap [Enlarge Display] in the side menu.

  4. If necessary, configure copy settings.

    supplementary explanationWhen specifying finishing for a copy job, refer to [Copy Settings (Basic)] .

    supplementary explanationWhen specifying the original to be copied, refer to [Copy Settings (Original/Density)] .

  5. If necessary, specify the number of copies using the keypad.

    supplementary explanationTapping [No. of Sets] displays the keypad.

    supplementary explanationTo change the number of copies, tap [C] (Clear).

  6. Use the Start key to start copying.

    supplementary explanationTo cancel copy, use the Stop key to stop copying. A list of the currently stopped jobs is displayed. Select the target job from the list, and delete it.

    supplementary explanationIf [Ready to accept another job.] is displayed during printing, you can scan the next original.

Reference

Making a trial printing (Proof copy)

Before beginning actual copying, do a single test copy and check it is acceptable.

When making a large number of copies, use the proof copy function to prevent a large number of miscopies from occurring.

  1. Load the original.

  2. Tap [Copy] on the main menu of classic style.

  3. Tap [Enlarge Display] in the side menu.

  4. If necessary, configure copy settings.

    supplementary explanationWhen specifying finishing for a copy job, refer to [Copy Settings (Basic)] .

    supplementary explanationWhen specifying the original to be copied, refer to [Copy Settings (Original/Density)] .

  5. Enter the number of copies using the keypad.

    supplementary explanationTapping [No. of Sets] displays the keypad.

    supplementary explanationTo change the number of copies, tap [C] (Clear).

  6. Tap [Print].

    supplementary explanationIf the original is loaded into the ADF, one copy is made. Proceed to step 10.

    supplementary explanationIf the original is loaded on the Original Glass, proceed to step 7.

  7. Load the next original, and use the Start key to start scanning.

  8. After all originals have been scanned, tap [Finish].

  9. Use the Start key to start copying.

    Copying begins for only one copy.

  10. Check the proof copy.

  11. When making the remaining copies, tap [Print].

    Copying begins for the remaining copies.