Post Inserter operations

Keys on the Control Panel

When the Post Inserter PI-507 is installed on the Finisher FS-540/FS-540 SD, you can manually operate the Finisher FS-540/FS-540 SD using the Post Inserter Control Panel.

No.

Name

Description

1

Corner Staple Lamp

Indicates that Corner Staple is selected.

2

Center Staple & Fold Lamp

Indicates that Center Staple and Fold is selected.

3

Finishing

Press this key to select the finishing.

4

2-Hole Lamp

Indicates that 2-Hole is selected.

5

3-Hole Lamp

Indicates that 3-Hole is selected.

6

Select punch

Press this key to select the number of punch holes.

7

Start/stop

Press this key to start the post inserter operation.

To stop the operation, press this key during operation.

8

4-Hole Lamp

Indicates that 4-Hole is selected.

9

Tri-Fold Lamp

Indicates that Tri-Fold is selected.

10

2 position staple lamp

Indicates that 2-position staple is selected.

Using the Post Inserter for finishing

preconditionOnly the Lower Tray can be used as the paper tray. The Upper Tray is not available for use.

  1. Load paper into the Lower Tray of the Post Inserter, then align the lateral guide with the paper size.

    supplementary explanationLoad the original by placing it so that its top side faces the back of the machine.

    supplementary explanationTo use the corner staple or 2-staple option, load the paper face up.

    supplementary explanationTo perform Punch, load the paper face up.

    supplementary explanationTo perform Bind, load the front side of the bound paper face down.

    supplementary explanationTo perform Tri-Fold, load the outside of the tri-folded paper face down.

    supplementary explanationIf the paper to be loaded is curled significantly, flatten the paper before loading it. Doing so may cause a paper jam or damage to the machine.

    supplementary explanationTo reuse paper that has been folded once, firmly flatten any creases before loading it. If paper remains creased, it may cause a folding-position misalignment or paper jam, or damage to the machine.

  2. Press the Finishing key and Select punch key, and select the desired finishing.

    supplementary explanationTo configure Finishing settings, press the Finishing key to turn the LED on. To configure punch settings, press the Select punch key to turn the LED on.

    supplementary explanationPunch settings are available together with the corner staple or 2-staple option.

  3. Press the Start/stop key.

    supplementary explanationIf the Start/stop key is pressed during operation, the operation will be stopped.