HomeBeschreibung der Funktionen / BedienerprogrammtastenPunch Horizontal Position Adjustment

Punch Horizontal Position Adjustment

To display:
  • [Utility]
    • [Expert Adjustment]
      • [Finisher Adjustment]
        • [Punch Horizontal Position Adjustment]

If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch hole positions.

Copy after configuration, then repeat adjustments as required.

This adjustment is possible when the Finisher FS-540/FS-540 SD and Punch Kit PK-526 are installed.

Setting

Description

[Finisher]/[Post Inserter]

Select the position subject to punch hole position adjustment.

  • [Post Inserter]: An adjustment is possible when the Post Inserter is installed on the machine.

[Adjust Value]

Enter the adjustment value between -5.0 mm and 5.0 mm (default: [0.0 mm]).

Increase the value when moving the punching hole rightward, and reduce it when moving the punching hole leftward.

This adjustment is possible when the Finisher FS-539/FS-539 SD and Punch Kit PK-524 are installed.

Setting

Description

[Paper Type]

Select the type of paper subject to punch hole position adjustment.

[Adjust Value]

Enter the adjustment value between -10 and 10 (default: [0]).

Increase the value when moving the punching hole rightward, and reduce it when moving the punching hole leftward.

  • This setting is displayed when the option is installed in this machine. For details on the required option, refer to Hier.

  • Make necessary adjustments while checking a sheet of paper containing punched holes that are not in the correct positions.