HomeControl PanelHow to Use the Power Key

How to Use the Power Key

When using this machine in factory default status
When using the Power key as a power save key

When using this machine in factory default status

For details on how to use the Power key in factory default status, refer to Here.

When using the Power key as a power save key

The Power key can be used as a power save key to manually switch to Power Save mode. Power Save mode is classified into two modes: Low Power mode and Sleep mode.

To use the Power key as a power save key, change the Power key setting (default: [Sub Power OFF]). For details, refer to Here.
Press the Power key to select whether to switch to Low Power or Sleep mode (default: [Low Power]). For details, refer to Here.

When the Power key is pressed, the status of this machine changes as shown below. The way status changes varies depending on how the Power key is pressed.

Power key	Status of this machine	Status of LED	Description
Short press	Low Power mode (Default value)	Flash: Blue	Turns off the display of the Touch Panel to reduce power use. This machine returns to the normal mode when it receives data or faxes or when the user operates the Touch Panel.
Short press	Sleep mode	Flash: Blue	Provides power-saving effect higher than Low Power mode. A time required to return to the normal mode is longer than Low Power mode. This machine returns to the normal mode when it receives data or faxes or when the user operates the Touch Panel.
Hold down	Sub Power OFF	Light up: Orange	Provides power-saving effect higher than Sleep mode. While the sub power is turned off, this machine can receive data or faxes, however, it cannot scan or print an original. To turn it on, press the Power key again. If data or faxes are received while the sub power is turned off, they are printed when the sub power is turned on.

Related setting (for the administrator)

Select whether to return to the normal mode without touching the Touch Panel when the machine is in Low Power mode or Sleep mode. Also, you can adjust the sensitivity of the sensor as necessary (Default: [ON], Adjustment value: [0]). For details, refer to Here.