To use application software with which the FTP server of this machine is used to communicate, configure the FTP server.
To use the FTP server of this machine for the association, follow the below procedure to configure the settings.
Enable the FTP server. Configure the security relevant settings.
In the administrator mode, select [Network] - [FTP Setting] - [FTP Server Setting], then configure the following settings.
Settings | Description |
---|---|
[FTP Server] | Select [ON] to use the FTP server. [ON] is specified by default. |
[Deny Reception Command] | Select a command to deny a receiving job from an FTP client when using the FTP server of this machine. Set this option to return an error when a PORT/EPRT command or PASV/EPSV command is sent from an FTP client to this machine. [Allow] is specified by default. |
[PORT Command Enhanced Security] | Select whether to enable the security of this machine against FTP bounce attacks. This option is not available if [Deny Reception Command] is set to [PORT/EPRT]. When a PORT/EPRT command is sent from an FTP client, the data connection is established only if both of the following conditions are satisfied:
[Enable] is specified by default. |