HomeFaxSending a Fax after Canceling ECM Mode (ECM)

Sending a Fax after Canceling ECM Mode ([ECM])

ECM

ECM is an error correction mode defined by ITU-T (International Telecommunication Union - Telecommunication Standardization Sector).

Fax machines that support the ECM communicate while confirming that there is no error in the sent data. This prevents image blurring caused by noise on the phone line.

By default, this machine uses ECM for transmission. If the noise level is high, the communication may take a little longer than the communication without using ECM checking. To reduce the transmission time, you can transmit faxes with ECM turned off.

Tips
  • When registering destinations with an address book, you can specify whether to send faxes in the ECM mode in addition to registering fax numbers.
  • If the ECM function is canceled, the following functions cannot be used together.
  • V34 OFF, Polling TX, Polling TX (Bulletin Board), Polling RX, Polling RX (Bulletin Board).

Operation flow

  1. Load the original.
  2. Tap [Scan/Fax].
  3. Specify the destination.
  4. Tap [Application] - [Fax Setting] - [Line Setting].
  5. Cancel the setting of [ECM], then tap [OK].
  6. Press the Start key.

    Transmission begins.