HomeDescriptions of Functions / Utility KeysProtocol Setting

Protocol Setting

To display:
  • [Utility]
    • [Administrator Settings]
      • [Network Settings]
        • [TCP/IP Settings]
          • [IPsec Settings]
            • [IPsec Settings]
              • [Protocol Setting]

Specify a protocol used for IPsec communication. Up to 10 protocols can be specified.

Select a group, then tap [Edit].

Settings

Description

[ON]/[OFF]

To register protocol settings, select [ON].

[OFF] is specified by default.

[Group Name]

Enter a group name for the protocol setting (using up to 10 characters).

[Protocol Identification Setting]

Select a protocol used for IPsec communication.

[Do Not Set] is specified by default.

[Port Specification Method]

If [TCP] or [UDP] has been selected in [Protocol Identification Setting], specify the port number used for IPsec communication.

[Message Type]

If [ICMP] or [ICMPv6] is selected in [Protocol Identification Setting], specify the type of ICMP message.

  • To check the registered protocol settings, select a group name, then tap [Mode Check].