HomeDescriptions of Functions / Utility KeysSNMP Setting

SNMP Setting

To display:

[Utility]
- [Administrator]
  - [Network]
    - [SNMP Setting]

Configure the settings to obtain information of this machine or to monitor the machine using Simple Network Management Protocol (SNMP).

Setting	Description
[SNMP Setting]	When enabling SNMP, set this option to ON (default: ON). [SNMP v1/v2c(IP)]: When using SNMP v1 or SNMP v2, set this option to ON (default: ON). [SNMP v3(IP)]: When using SNMP v3, set this option to ON (default: ON).
[UDP Port Setting]	If necessary, change the UDP port number (default: [161]).
[SNMP v1/v2c Setting]	Configure SNMP v1/v2c settings. [Read Community Name]: Enter a read-only community name (using 1 to 15 characters, excluding spaces, \, ', ", and #) (default: [public]). [Write Community Name]: When allowing reading and writing, set this option to ON (default: ON). Also enter a community name used for reading and writing (using 1 to 15 characters, excluding spaces, \, ', ", and #) (default: [private]).
[SNMP v3 Setting]	Configure SNMP v3 settings. [Context Name]: Enter the context name (using up to 63 characters, excluding spaces, \, ', ", and #). [Discovery User Name]: When allowing the detection user, set this option to ON (default: ON). Also, enter a user name for detection (using 1 to 32 characters, excluding spaces, \, ', ", and #) (default: [public]). [Read User Name]: Enter a read-only user name (using up to 32 characters, excluding spaces, \, ', ", and #) (default: [initial]). [Security Level]: Select a security level of the user in the read-write enable state (default: [auth-password/priv-password]). [auth-password]: If [auth-password] or [auth-password/priv-password] is selected from [Security Level], enter an authentication password for the read-only user (using 8 to 32 characters, excluding spaces, \, ', ", and #). [priv-password]: If [auth-password/priv-password] is selected from [Security Level], enter a password used for privacy (encryption) of the read-only user (using 8 to 32 characters, excluding spaces, \, ', ", and #). [Write User Name]: Enter the user name of the user in the read-write enable state (using up to 32 characters) (default: [restrict]). [Security Level]: Select a security level of the user in the read-write enable state (default: [auth-password/priv-password]). [auth-password]: If [auth-password] or [auth-password/priv-password] is selected from [Security Level], enter an authentication password for the read-write enabled user (using 8 to 32 characters, excluding spaces, \, ', ", and #) (default: MAC address of this machine (Alphabetic characters are all in capitals, excluding colons (:)). [priv-password]: If [auth-password/priv-password] is selected from [Security Level], enter a password used for privacy (encryption) of the read-write enabled user (using 8 to 32 characters, excluding spaces, \, ', ", and #) (default: MAC address of this machine (Alphabetic characters are all in capitals, excluding colons (:)). [Encryption Algorithm]: Select an encryption algorithm (default: [DES]). [Authentication Method]: Select an authentication algorithm (default: [MD5]).
[TRAP Setting]	Configure settings for the SNMP TRAP function. [Allow Setting]: When allowing a notification of the status of this machine using the SNMP TRAP function, set this option to ON (default: ON). [Trap Setting when Authentication Fails]: When performing TRAP TX due to an authentication failure, set this option to ON (default: OFF).