Cleaning This Machine

Cleaning the Slit Scan Glass

  1. Open the ADF.

  2. Wipe stains off the Slit Scan Glass using a dry, clean cloth.

    NOTICE
    • Do not touch the Slit Scan Glass.

Cleaning the Slit Scan Glass (back)

  1. Open the ADF.

  2. Open the Opening and Closing Guide.

    supplementary explanationRelease the lock lever of the Opening and Closing Guide, and open the Opening and Closing Guide.

  3. Wipe stains off the Slit Scan Glass (back) using a dry, clean cloth.

    NOTICE
    • Do not touch the Slit Scan Glass (back).

  4. Close the Opening and Closing Guide you opened in step 2.

    supplementary explanationPress the Hand mark in the center of the Opening and Closing Guide, and check that the Opening and Closing Guide is locked securely.

Cleaning the Original Glass, Control Panel, roller, and Output Belt

Wipe the surface using a soft, dry cloth.

When cleaning the Output Belt, make sure that the Finisher FS-540 SD is installed on this machine.

NOTICE
  • Do not press the Control Panel hard, otherwise the Touch Panel may be damaged.

CAUTION
  • The inside of this product has areas subject to high temperature, which may cause burns. When checking the inside of the unit for malfunctions such as a paper misfeed, do not touch the locations (around the fusing unit, etc.) which are indicated by a "Caution HOT" caution label. A burn could result.

Cleaning the outer covers and Original Pad

Wipe the surface using a soft cloth moistened with a mild household detergent.

NOTICE
  • Never use solvents, such as benzene or thinner, to clean the Original Pad.