HomeFaxBasic Option Settings

Basic Option Settings

Scanning a double-sided original ([Simplex/Duplex])

Using the ADF, you can automatically scan the front and back faces of an original. Also, you can scan only one side of the first page, then scan both sides for the remaining pages.

For details, refer to Here.

Specifying the resolution of an original for scanning ([Resolution])

Select the resolution of the original for scanning.

For details, refer to Here.

Specifying the original size for scanning ([Scan Size])

Select the size of the original to be scanned. Select the key that shows the same size as for the original to be scanned.

To scan an original of custom size, manually specify the size.

For details, refer to Here.

Scanning a number of originals in several batches ([Separate Scan])

If the number of original sheets is so large that they cannot be loaded into the ADF at the same time, you can load them in several batches and handle them as one job.

In [Separate Scan], you can switch between the ADF and Original Glass to scan the originals.

  1. Load the original.

    • Do not load more than 100 sheets (20 lb (75 g/m2)) at a time into the Original Tray, and do not load sheets above the upper-limit indicator guide. Doing so may cause an original paper jam, damage the originals, and/or cause an ADF failure.

  2. Tap [Separate Scan], then set to [ON].

  3. Press the Start key.

    The original is scanned.

  4. Load the next original, then press the Start key.

    • Tap [Change Setting] to change the option settings according to the new original as necessary.

  5. Repeat Step 4 until all originals have been scanned.

  6. After all originals have been scanned, tap [Finish] and press the Start key.

    Transmission begins.

  • Select whether to always scan originals continuously without specifying [Separate Scan] when scanning originals using the Original Glass (Default: [No]). For details, refer to Here.