Sending

Sending (Basic operation flow)

This section describes how to perform the scan/fax transmission when using the Enlarge Display function.

  1. Load the original.

    supplementary explanationWhen loading the original into the ADF, pull out the Document Stopper (1) to prevent the scanned original from falling.

  2. Tap [Scan/Fax] on the main menu of classic style.

  3. Tap [Enlarge Display] in the side menu.

  4. Specify the destination.

    supplementary explanationFor details on how to specify a destination, refer to [Specifying a Destination] .

    supplementary explanationIf [Dest. Settings] is tapped, you can view the list of the selected destinations.

  5. When necessary, tap [Scan Settings] to configure option settings of the scan transmission.

    supplementary explanationSpecify the size of the target original in [Scan Size] (default: [8-1/2 11] (inch area)/[A4] (centimeter area)). If you fail to set the original size correctly, the image may be cut off.

    supplementary explanationFor details on option settings, refer to [Scan/Fax Transmission Option Settings] .

  6. Use the Start key to start transmission.

    supplementary explanationUsing the Stop key enables you to stop scanning the original. A list of the currently stopped jobs is displayed. To stop transmission, select the target job from the list, and delete it.

Reference

Sending after recalling the scan/fax program

The scan/fax program contains a combination of commonly-used settings as one recall key. For transmission, recall the scan/fax program with a single touch of a button on the main screen of Enlarge Display.

preconditionThe scan/fax program must be registered on the normal screen in advance. For details on the registration procedure, refer to [Registering a Scan/Fax program] .

  1. Load the original.

  2. Tap [Scan/Fax] on the main menu of classic style.

  3. Tap [Enlarge Display] in the side menu.

  4. Tap the icon to recall the program.

  5. Select the program you want to recall, and tap [OK].

    The registered content of a program is applied.

  6. Specify a destination if no destination is registered in Program.

    supplementary explanationFor details on how to specify a destination, refer to [Specifying a Destination] .

  7. Use the Start key to start transmission.