HomeDescriptions of Functions / Utility KeysCenter Staple Position

Center Staple Position

To display:
  • [Utility]
    • [Administrator Settings]
      • [System Settings]
        • [Expert Adjustment]
          • [Finisher Adjustment]
            • [Center Staple Position]

If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple position on the fold.

Copy after configuration, then repeat adjustments as required.

Settings

Description

[Paper Size]

Select the size of paper that is used to adjust the staple position.

[Adjust Value]

Enter an adjustment value between -10.0 and 10.0 mm by tapping [-] and [+].

  • [-]: Move the staple position to the left.

  • [+]: Move the staple position to the right.

[0.0 mm] is specified by default.

  • To use this function, the optional Finisher FS-534 SD is required.

  • Adjust the half-fold position before adjusting the center staple position.

  • Make adjustment while checking paper stapled at a displaced position.

  • The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.

  • For adjustments to put staples parallel with the left edge of paper, contact your service representative for instructions.