Cleaning the Saddle Stitcher SD-513
The conveyance belt of the bundle exit tray should be kept clean, otherwise soil marks may be printed. Follow the procedure below to clean the conveyance belt of the bundle exit tray.
In order to maintain optimum print quality, we recommend to clean it every time before using this tray.
If any soil marks are found on the conveyance belt while printing, perform this cleaning procedure immediately.
Open the clamp section upper door.
The clamp section upper door cannot be opened while the saddle stitcher is in the initializing state. After initializing is completed, open the upper door.
Wipe the surface of the two conveyance belts with a soft cloth dampened slightly with alcohol (cleaner).
Move the conveyance belt to clean the entire conveyance belt.
Raise the two conveyance belts lightly with hands, then pull them both to the left at the same time in order to show the hidden parts.
Clean the conveyance belts using a soft cloth dampened with alcohol (cleaner).
Repeat steps 2 and 3 (about three times) to clean the whole round of the belt.
Do not pull the conveyance belt while the saddle stitcher is in the initializing state. Forcibly pulling it causes a machine trouble. When pulling the conveyance belt, make sure to open the clamp section upper door after saddle stitcher initializing is completed.
Do not raise the conveyance belt higher than necessary. Or, never fail to pull the two belts at the same time. Pulling only one belt may result in damage to the machine.
Clean the bottom plate of the bundle exit tray.
Wipe the whole surface of the bottom plate with a soft cloth slightly dampened with alcohol (cleaner).
Close the clamp section upper door.
