This section describes how to return the Color Default Settings of the image controller to the factory default.
The factory default settings are as follows;
[RGB] Tab | Setting |
---|---|
[Off] | OFF |
[RGB-CMYK Device Link Profile] | OFF |
[RGB Source Profile] | ON |
[Rendering] | [Saturation] This setting may vary depending on models. |
[CMYK] Tab | Setting |
---|---|
[Off] | OFF |
[CMYK-CMYK Device Link Profile] | OFF |
[CMYK Target Profile] | ON |
[Paper Simulation] | OFF |
[Printer Profile] Tab | Setting |
---|---|
[Printer Profile] | For coated paper |
[Paper Type Link] | OFF |
[Optional Settings] tab | Setting |
---|---|
[Tone Curve] - [Image] | [No Setting] |
[Tone Curve] - [Text/Graphic] | [Same as Image] |
[Tone Curve] - [Keep 100% Density for Text/Graphics] | OFF This function is not available on color machines. |
[Pure Black] | [Text/Graphic] |
[Black Overprint] | OFF |
[Gray Replacement] - [RGB] | [Text/Graphic] |
[Gray Replacement] - [CMYK] | [Image/Graphics/Text] |
[Composite Overprint] | [Off] |
[Use Spot Color] | ON |
[AlternativeColor Table] | [No Setting] |
[Use Embedded RGB Profile] | ON |
[Use Embedded CMYK Profile] | OFF |
[RGB Simulation] | OFF |
[PDF/X output intent] | OFF |
[Use CIE Color] | This function is not available on color machines. |
From the [File] menu, select [Return to Factory Default].
The [Initialization Check] message is displayed.
Click [Yes].
Resets the priority to the factory default.
When you want to register the initialized settings of Color Default, go to Register Color Default Settings.