Adjust the trim position in the crosswise direction.
Adjustment / Maintenance
Trimmer Unit TU-510
Trimming timing selection key
Select what numbered trimming position is adjusted.
Used to enter numeric values.
Returns the entered numeric value to "0".
Sets the numeric value entered using the keypad to the selected setting item.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [Four Edge Trim Mode] - [CD Trim Position]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Trimmer Unit Adjustment] - [Finishing Position Adj.] - [Four Edge Trim Mode] - [CD Trim Position]
If a trimmer profile is set, you can only select the same paper size as the size set in the trimmer profile.
Only when the trimmer profile is set, trimming can be set in [Trim] of [Output Setting].
A sample is output.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To move the trim position to the lead edge, (+) To move the trim position to the rear edge
[Adj. Range:-50~+50 1step = 0.1mm]