Adjust the alignment plate position in the crosswise direction of the Relay Unit RU-510 to eliminate misalignment of punch holes.
This function is available when paper is conveyed while it remains bent or skewed against the next-stage finisher.
Adjustment / Maintenance
Relay Unit RU-510
Used to enter numeric values.
Returns the entered numeric value to "0".
Sets the numeric value entered using the keypad to the selected setting item.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Relay Stacker Adjustment] - [Paper Width Adjustment]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Relay Stacker Adjustment] - [Paper Width Adjustment]
A sample is output. This section describes a sample with punch holes.
a: Misalignment occurs if the pitch of the alignment plate is wider than the paper width.
b: A distortion occurs in punch holes if the pitch of the alignment plate is narrower than the paper width.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[-] To reduce the dispersion, [+] To reduce the misalignment
[Adj. Range:-20~+20 1step = 0.1mm]
To make adjustments, set the paper width adjustment value to the maximum (to reduce misalignment), adjust in the direction to reduce dispersion , and find a point at which the through hole of the punch holes is not misaligned.