Adjust the alignment width in the fore-edge direction (paper feed direction) of the body in the clamp unit.
Make this adjustment when misalignment or distortion occurs in the fore-edge direction of the body during perfect binding using Perfect Binder PB-503.
Adjustment / Maintenance
Perfect Binder PB-503
[Offset for All Size]
Adjusts the alignment width common to all sizes.
Paper size selection key
Selects the paper size to adjust.
[+] / [,]
Switches the paper size page.
Sets the numeric value entered using the keypad to the selected setting item.
The sizes referred to in this section are those of bodies corresponding to cover sizes.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Perfect Binder Adjustment] - [Clamp FD Position Adj.]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Perfect Binder Adjustment] - [Clamp FD Position Adj.]
When using any paper tray, you need to set a cover tray by selecting [Perfect Bind] of [Output Setting]. For details, refer to [Cover Tray].
A perfect binding sample is output.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
(-) To reduce the distortion, (+) To reduce the misalignment
[Adj. Range:-20~+20 1step = 0.1mm]