Adjust the trimming width on the fore-edge side on the saddle stitcher.
Make this adjustment when there is a problem with the printout finishing.
Adjustment / Maintenance
[Offset for All Size]
Adjusts the trimming width common to all the paper sizes.
Paper size selection key
Selects the paper size to adjust.
[+] / [,]
Switches the paper size page.
Used to enter numeric values.
Returns the entered numeric value to "0".
Sets the numeric value entered using the keypad to the selected setting item.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Trimming Adjustment]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Trimming Adjustment]
A sample is output.
Before printing, always pull out the Fold/Staple mode tray. Otherwise, a sample is not output even if you press Start on the Control panel.
Standard value: a = 2.0 mm or more
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-400~+400 1step = 0.1mm]
Set the trimming width so that the cover is trimmed by 2.0 mm or more. If the trimming width is below 2.0 mm, it may cause a trimming failure.