Adjust the staple pitch when stapling on the saddle stitcher.
Make this adjustment when misalignment or distortion occurs on the paper stack during stapling.
Adjustment / Maintenance
[Offset for All Size]
Adjusts the staple pitch common to all sizes.
Paper size selection key
Selects the paper size to adjust.
[+] / [,]
Switches the paper size page.
Used to enter numeric values.
Returns the entered numeric value to "0".
Sets the numeric value entered using the keypad to the selected setting item.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Staple Pitch Adjustment]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Saddle Stitcher Adjustment] - [Staple Pitch Adjustment]
Before printing, always pull out the Fold/Staple mode tray. Otherwise, a sample is not output even if you press Start on the Control panel.
A sample is output.
Standard value: a = b/2 -2.0 mm to +2.0 mm
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
The adjustment range is restricted depending on the paper size. For the minimum value, the stapler's movable range is restricted. For the maximum value, there is no interference between the alignment plate for Fold & Staple and the stapler.
w[B5v]: Unavailable (91 mm fixed)
w[B4w]: -20 mm to +20 mm (108.5 mm to 148.5 mm)
w[A4w]: -14 mm to +14 mm (91 mm to 119 mm)
w[A3w]: -20 mm to +16.5 mm (128.5 mm to 165 mm)