Adjust the loop amount of the registration roller section in the staple finisher when feeding paper from the PostInserter PI-502.
Perform this adjustment when problems such as bending or wrinkling of the paper, or paper jams occur.
Adjustment / Maintenance
Finisher FS-541 with PostInserter PI-502 mounted
[PI Upper Tray]
Adjusts the loop amount of the upper tray.
[PI Lower Tray]
Adjusts the loop amount of the lower tray.
Used to enter numeric values.
Returns the entered numeric value to "0".
Sets the numeric value entered using the keypad to the selected setting item.
Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Staple Finisher Adjustment] - [Staple Finisher(PI) Adj.] - [PI Registration Adjustment]
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Staple Finisher Adjustment] - [Staple Finisher(PI) Adj.] - [PI Registration Adjustment]
[PI Upper Tray]: Exit the [Adjustment] menu once, and follow the normal printing procedure to output a job that is fed from the Upper tray.
[PI Lower Tray]: Select any output mode on the Control panel of PostInserter PI-502, and press Start/Stop button.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-5~+5 1step = 1mm]