Home Adjust the output resultBoth Sides Adjust: Adjusting the Horizontal/Vertical Magnification

Both Sides Adjust: Adjusting the Horizontal/Vertical Magnification

If there is misalignment on the front/back side, or if the magnification is not as desired, you can specify your desired print magnification.

As an example, how to adjust an unwanted 1% vertical extension (in the X-Y direction) of the print image on the back side is explained below.

• Meaning and Purpose of Horizontal/Vertical Magnification Adjustment

  • When the print position on the front/back side of a print is misaligned or when the magnification is not as desired, this function allows you to reduce or enlarge the whole print area by specifying the horizontal/vertical magnification.

  • Adjustable range with this setting

• When to perform

  • When the front/back side printing magnification is not as desired

  • When the print position on the front/back side of a print cannot be adjusted as desired using the Image Shift adjustment (Both Sides Adjust: Adjusting the Image Shift)

•Intended Environment

Image Controller

Built-in image controller

* The sample screen may be different from the actual display depending on your system environment.

•Precautions

  1. Print the original and measure the misalignment on the front and back sides using a scale magnifier.

    Each page of the sample pdf document has register marks (+ marks) printed on the front and back sides.

    As an example, how to adjust an unwanted 1% vertical extension (in the X-Y direction) of the print image on the back side is explained below.

  2. On the touch panel of the main body, press [Paper Setting] on the [MACHINE] screen.

    You can also press [Paper Setting] on the [COPY] screen to display the same screen.

  3. Select the tray in which the papers are loaded and press [Change Set].

    Example: [Tray 1] is selected.

  4. On the [Change IndividualSet] screen, press [Both Sides Adj.].

  5. Select the side to adjust by pressing [Front] or [Back].

    Example: Adjust the horizontal/vertical magnification for the [Back] side. To adjust the horizontal/vertical magnification of the front side, press [Front].

    • You can also press [Both Sides] on the [MACHINE] screen and select a tray on the left side.

  6. Press [Vertical] and/or [Horizontal] under [Zoom]. Enter a value or values. When the adjustment is completed, press [OK].

    Example: Adjust the vertical magnification from the [Vertical] option. To adjust the horizontal magnification, press [Horizontal].

    Item

    Setting

    [Vertical]

    1% reduction (-100)

    • Press [Vertical], [+/-], [1], [0], and [0] to enter [-1.00%]. This reduces the print image on the back side by 1%.

    After adjusting the settings, press [OK].

    • Press the keypad on the screen to set the value.

    • Use [+/-] to specify the value to be positive or negative.

    • The values are in 0.01% increments. (1 = 0.01 %)

    • Press [] to increment the value and [] to decrement the value.

  7. Print the original again and check the print position.

    Repeat the above steps until the desired print positions on the front and back sides are obtained.

    • As a general rule, set the horizontal/vertical magnification for each paper type. It is recommended that frequently used paper settings be saved as a paper profile. (Refer to Registering Paper Profile (Paper Catalog).)