Home Job OperationsApplication

Application

Configure any application setting to scan data.

[Frame Center Erase]
[Function Selection]: [Erase/All Sides], [Erase/Each Side], [Center Erase]

[Erase Width Setting]
When [Erase/All Sides] is selected: Specify [Top], [Bottom], [Right], and [Left] between 1 mm and 300 mm to set all the widths to be erased.
When [Erase/Each Side] is selected: Specify [Top], [Bottom], [Right], and [Left] between 1 mm and 300 mm to set each width to be erased.
When [Center Erase] is selected: Specify the width to be erased between 1 mm and 99 mm.

[Full Image Area]

[Annotation]

[Annotation Select]
Recalls [Annotation Setting] registered in [UTILITY] - [Administrator Setting] - [System Setting] - [Annotation Setting].

[Temp.No.Set]
Press this button to temporarily change [Annotation No.] that is registered, then enter the changed number.

[Print Pos. Setting]
: Specify the desired annotation printing position.

[Fine Adjustment ]
: Fine-adjusts the annotation printing position.

[OK]
Applies the setting.

[Cancel]
Cancels the setting.

[Function OFF]
Turns the function of the selected setting off when [Function OFF] is pressed on the individual setting screen.