Loading the Original into the ADF
Original available for ADF
Item | Specifications |
|---|---|
Original types | Plain paper (13-5/16 lb to 34-1/16 lb (50 g/m2 to 128 g/m2)) |
Max. original size | 8-1/2 Fax mode: 8-1/2 inches to 39-3/8 inches (216 mm to 1,000 mm) |
Original loading capacity | Max. 50 sheets (21-1/4 lb (80 g/m2)) |
Do not load the following originals into the ADF. Doing so may cause an original paper jam, or damage the originals.
Wrinkled, folded, curled, or torn originals- Highly translucent or transparent originals, such as transparencies or diazo photosensitive paper
- Coated originals such as carbon-backed paper
- Original that weighs less than the basic weight of 13-5/16 lb (50 g/m2), or more than 34-1/16 lb (128 g/m2)
- Originals that are bound, for example, with staples or paper clips
- Originals that are bound in booklet form
- Originals with pages bound together with glue
- Originals with pages that have had cutouts removed or are cutouts
- Label sheets
- Offset printing masters
- Photographic Paper
- Glossy original such as gloss coated paper
Reference- If there are too many original sheets that cannot be loaded into the ADF at the same time, you can load them in several batches and handle them as one job. For details, refer to [Scanning a number of originals (Separate Scan)] .
- Using the ADF allows you to collectively scan the originals of paper sizes 8-1/2
11 and 8-1/2 14, which have the same width. For details, refer to [Scanning originals of varying sizes in a batch (Mixed Original)] .
Loading the original into the ADF
The ADF feeds original sheets one by one in order from the top, and automatically loads them. It also loads a 2-sided original automatically.
The ADF is helpful when loading a large number of original.
Put the first page of an original at the top, and load the original into the Original Tray with the required side facing upward.
Load the original so that its top side is placed on the left. When loading in a different orientation, be sure to specify the loading direction of originals.For details on the loading direction of originals, refer to [Specifying the original loading direction (Original Direction)] .
NOTICE- Do not load more than 50 sheets (21-1/4 lb (80 g/m)) at a time into the Original Tray, and do not load the sheets up to the point where the top of the stack is higher than the
mark. Doing so may cause the originals to jam, damage the originals, and/or an ADF failure. However, if the original contains more than 50 sheets (21-1/4 lb (80 g/m)), it can be scanned separately.
Slide the Lateral Guide to fit the loaded original.