Adjusting the Touch Panel

Adjusting a position to tap the Touch Panel

If a Touch Panel key does not respond normally when tapped, it may not be detected properly.

  1. Tap [Accessibility] - [Touch Panel Adjustment].

    supplementary explanationIf a keying error recurs even after [Touch Panel Adjustment] is tapped, press 1 on the Keypad.

  2. Press the Start key.

  3. Tap [+] on the screen.

    supplementary explanationIf two [+] buttons are displayed, tap the second [+] while holding down the first [+].

    supplementary explanationTo stop the adjustment, press the Stop key.

    Tap [+] 10 times, then start adjusting a position gap.

    Re-operate the screen that did not respond properly before adjustment, and check that the keying position is adjusted correctly.

Tips

  • After this procedure, if a keying error recurs, contact your service representative.

Adjusting the brightness of the Touch Panel

Adjust the brightness level of the Touch Panel.

  1. Tap [Accessibility] - [Brightness Adjustment], and select [Low] or [High] to adjust the brightness.

Setting an operation for continuous tapping

Select whether continuous tapping of the same key is detected as a double-tap operation.

  1. Tap [Accessibility] - [Double tap setting].

    Settings

    Description

    [Double Tap]

    Detects continuous tapping of the same key as a double-tap operation.

    Change the double-tap detection interval at five levels.

    Double-tap the box at the right of the screen to check the current setting.

    [Standard] is specified by default.

    [Tap detection Limitation]

    Inhibits the system from detecting the second and subsequent taps in the specified interval when the same key is tapped continuously.

    When a user continuously touches a key in an involuntary manner, the system prevents it from being mistakenly detected as a double-tap operation.

    Specify the interval to detect the second and subsequent taps.

    [0.1 sec.] is specified by default.